A Space & astronomy forum. SpaceBanter.com

Go Back   Home » SpaceBanter.com forum » Space Science » Space Shuttle
Site Map Home Authors List Search Today's Posts Mark Forums Read Web Partners

NASA APPOINTS BOARD TO INVESTIGATE SHUTTLE ARM INCIDENT



 
 
Thread Tools Display Modes
  #1  
Old March 18th 06, 11:04 AM posted to sci.space.shuttle
external usenet poster
 
Posts: n/a
Default NASA APPOINTS BOARD TO INVESTIGATE SHUTTLE ARM INCIDENT

March 17, 2006

Katherine Trinidad
Headquarters, Washington
(202) 358-3749

Jessica Rye
Kennedy Space Center, Fla.
(321) 867-2468

RELEASE: 06-100

NASA APPOINTS BOARD TO INVESTIGATE SHUTTLE ARM INCIDENT

NASA has formed a board at the agency's Kennedy Space Center, Fla., to
investigate the March 4 incident that damaged Space Shuttle
Discovery's remote manipulator system (shuttle arm).

Hugo Delgado is chairman of the five-member investigation board. He is
deputy director for the Office of the Chief Engineer at Kennedy. The
board is supported by one ex-officio member, four advisors and
administrative personnel.

Board functions include investigating the facts surrounding the
incident, determining its probable cause, assessing the possibility
of a recurrence and recommending corrective actions. A final report
is expected this summer.

On March 4 at about 10:10 p.m. EST, shuttle technicians inside a
bridge bucket work platform device accidentally bumped into
Discovery's robotic arm. The arm is a 50-foot-long, jointed extension
used to grapple payloads, remove them from the payload bay and move
spacewalking astronauts to various work platforms.

Inspections showed two indentations in the arm's outer bumper layer, a
Kevlar-covered plastic, honeycombed structure designed to protect the
arm from minor impacts. One of the indentations in the honeycombed
layer is oval shaped, 0.115 inch deep and 1 inch in diameter.

The second indentation, also oval shaped, is 0.035 inch deep and 0.5
inch in diameter. Ultrasound inspections were performed once the
Kevlar and honeycombed layer were removed.

Under the largest indentation was a small crack in the carbon-fiber
composite, measuring 1.25 inches long and 0.015 inches deep. The arm
was removed from the vehicle on Tuesday and will be sent back to the
vendor for repair.

The shuttle is in Kennedy's Orbiter Processing Facility bay 3. It is
undergoing preparations for the STS-121 mission to the International
Space Station. The launch is targeted for no earlier than July 1.

For more information about the Space Shuttle Program and the STS-121
mission on the Web, visit:

http://www.nasa.gov/shuttle

For information about NASA and agency programs on the Web, visit:

http://www.nasa.gov/home


-end-


--
--------------

Jacques :-)

www.spacepatches.nl


 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Unofficial Space Shuttle Launch Guide Steven S. Pietrobon Space Shuttle 0 October 3rd 05 05:36 AM
Unofficial Space Shuttle Launch Guide Steven S. Pietrobon Space Shuttle 0 July 4th 05 07:50 AM
Review board says shuttle safe despite NASA failure to fully implement three CAIB recommendations Jacques van Oene Space Shuttle 3 July 1st 05 09:25 PM
Unofficial Space Shuttle Launch Guide Steven S. Pietrobon Space Shuttle 0 August 5th 04 01:36 AM
Unofficial Space Shuttle Launch Guide Steven S. Pietrobon Space Shuttle 0 April 2nd 04 12:01 AM


All times are GMT +1. The time now is 04:11 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright ©2004-2025 SpaceBanter.com.
The comments are property of their posters.