![]() |
|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
![]()
On Aug 30, 2:28*pm, Jeff Findley wrote:
In article 929065a9-0332-442c-b676-421861950df9 @c4g2000vbe.googlegroups.com, says... On Aug 29, 9:33 am, Jeff Findley wrote: The pressure hull of the LEM was aluminum so thin that it wouldn't take much to accidentally put a hole in it. Apollo astronauts were real men who knew the risks, but flew anyway. thinner than a pop can ![]() I don't think that's quite true. A quick web search says the skin of the LEM pressure vessel was, at its thinnest, 12/1000 of an inch thick. *One source I found for aluminum (pop) can wall thickness stated 5/1000 of an inch thick, which is less than half the thickness of the LEM's skin. Jeff -- "the perennial claim that hypersonic airbreathing propulsion would magically make space launch cheaper is nonsense -- LOX is much cheaper than advanced airbreathing engines, and so are the tanks to put it in and the extra thrust to carry it." - Henry Spencer Pop cans during the apollo era were much heavier than today. They have fond ways to lighten cans a lot. Alunimum is expensive......... it was one to cut costs |
#12
|
|||
|
|||
![]() |
|
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Apollo question | [email protected] | Space Shuttle | 9 | April 27th 12 10:16 PM |
Apollo 11 question | GordonD | History | 25 | September 21st 11 12:15 PM |
Apollo 13 question | Pat Flannery | History | 6 | July 24th 06 01:54 AM |
Apollo 11 question | Pat Flannery | History | 2 | July 18th 05 01:36 AM |
Apollo One Question | [email protected] | History | 29 | December 23rd 04 10:29 PM |