|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Gravity Probe B gyroscopes ready for full-speed spin-up (Forwarded)
Don Savage
NASA Headquarters (202) 358-1547 Steve Roy Media Relations Dept. (256) 544-0034 Robert Kahn Stanford University, Stanford, Calif. (650) 723-2540 For release: 07/20/04 Status report no.: 04-193 Gravity Probe B gyroscopes ready for full-speed spin-up Nearly three months in orbit, Gravity Probe B, a NASA experiment to test two predictions of Albert Einstein, continues to perform well. All four gyroscopes — the ultra-precise spheres that will be used to test Einstein's general theory of relativity — are ready for full-speed spin-up. Nearing the end of its in-orbit and calibration phase, Gravity Probe B is managed by the Marshall Center. At just under three months in orbit, Gravity Probe B is nearing the end of the Initialization and Orbit Checkout (IOC) phase of the mission. The spacecraft remains in excellent health, and all subsystems are continuing to perform well. All four gyros are digitally suspended, with gyros #2 and #4 spinning at science mission speed-greater than 80Hz (4,800 rpm) -- and gyros #1 and #3 spinning at approximately 1.5 Hz (90 rpm), ready for full-speed spin-up. The updated drag-free thruster control software that was uploaded to the spacecraft three weeks ago to optimize performance of the Attitude and Translation Control system (ATC) is continuing to perform nominally. The spacecraft's roll rate is 0.52 rpm, and the science telescope is being re-locked onto the guide star, IM Pegasi, following the full-speed spin-up of gyro #2 yesterday. Each full-speed spin-up takes most of a day. Helium gas is flowed over the gyro for 90 seconds, and tests are run to ensure that the helium usage rate for that gyro corresponds to previous measurements. If all measurements check out, the full-speed spin-up, in which helium gas is flowed over the rotors for 2-3 hours, commences. The GP-B operations team controls the spin-up process by sending commands from the Mission Operations Center (MOC) at Stanford to the spacecraft. Real-time telemetry provides immediate feedback on the progress of the spin-up so that various parameters can be adjusted as necessary. The spacecraft is being controlled from the Gravity Probe B Mission Operations Center, located at Stanford University. The Stanford-NASA/MSFC-Lockheed Martin operations team is continuing to perform superbly. NASA's Marshall Space Flight Center in Huntsville, Ala., manages the Gravity Probe B program for NASA's Office of Space Science. Stanford University in Stanford, Calif., developed and built the science experiment hardware and operates the science mission for NASA. Lockheed Martin of Palo Alto, Calif., developed and built the GP-B spacecraft. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gravity Probe B mission status report for 04/28/2004 (Forwarded) | Andrew Yee | Astronomy Misc | 0 | May 4th 04 10:15 PM |
Gravity Probe B launch postponed (Forwarded) | Andrew Yee | Astronomy Misc | 0 | November 21st 03 07:27 PM |
Europe's first Moon probe prepares for launch (Forwarded) | Andrew Yee | Astronomy Misc | 0 | August 11th 03 07:18 PM |
Einstein's Gravitational Waves May Set Speed Limit For Pulsar Spin | Ron Baalke | Astronomy Misc | 1 | July 3rd 03 08:49 AM |