Daily Rpt #4931

HUBBLE SPACE TELESCOPE - Continuing to Collect World Class Science

DAILY REPORT #4931

PERIOD COVERED: 5am September 15 - 5am September 16, 2009 (DOY 258/09:00z-259/09:00z)

OBSERVATIONS SCHEDULED

COS/FUV 11482

FUV Detector Dark

The purpose of this proposal is to measure the FUV detector dark rate
by taking long science exposures with no light on the detector. The
detector dark rate and spatial distribution of counts will be compared
to pre-launch data in order to verify the nominal operation of the
detector, and for use in the CalCOS calibration pipeline. Variations
of count rate as a function of orbital position will be analyzed to
find dependence of dark rate on proximity to the SAA.

This is SMOV Activity COS-24.

COS/FUV 11492

FUV Sensitivity

This activity confirms COS sensitivity versus wavelength over the
entire observable spectrum for all FUV gratings and central wavelength
settings. Obtain quick look sensitivity visit early in SMOV. Later,
after wavelength calibration is verified, perform a precise-centering
acquisition and observe an appropriate HST flux standard star (chosen
from the HST prime standard and FASTEX lists) with the PSA. (A limited
BOA characterization is obtained in Visit 13 using primary standard
GD153.) No off aperture- center observations are performed in this
activity (see COS32, program 11490, for off- center
characterizations). Spectra will be obtained to meet a Poisson S/N
criterion of ~30 per sensitivity extraction bin or higher;
substantially higher S/N characterization will be utilized in routine
Cycle 17 calibration.

COS/FUV 11897

FUV Spectroscopic Sensitivity Monitoring

The purpose of this proposal is to monitor sensitivity in each FUV
grating mode to detect any changes due to contamination or other
causes.

COS/FUV 11997

FUV Internal/External Wavelength Scale Monitor

This program monitors the offsets between the wavelength scale set by
the internal wavecal versus that defined by absorption lines in
external targets. This is accomplished by observing two external
targets in the SMC: SK191 with G130M and G160M and Cl* NGC 330 ROB B37
with G140L (SK191 is too bright to be observed with G140L). The
cenwaves observed in this program are a subset of the ones used during
Cycle 17. Observing all cenwaves would require a considerably larger
number of orbits. Constraints on scheduling of each target are placed
so that each target is observed once every ~2-3 months. Observing the
two targets every month would also require a considerably larger
number of orbits.

COS/NUV/FUV/WFC3/UVIS/IR 11534

COS-GTO: Atmosphere of a Transiting Planet

COS observations of a transiting planet at different orbital locations
will be useful in identifying the chemical content, size, temperature,
and flows in the atmosphere of a transiting planet.

FGS 11942

Increasing the Accuracy of HST Astrometry with FGS1R

We propose to observe six exoplanetary system host stars and two
planetary nebulae central stars with FGS1R. All objects have been
previously observed under proposals GO-09233, -09969, -10989, and
-11210. These observations will significantly extend the time
baseline, permitting improvements in the determination of proper
motion. This systematic motion must be removed to get at the
perturbation of interest, either due to exoplanetary companions or the
orbital motion of the Earth (parallax). In most cases the perturbation
orbits will also improve. We improve either companion mass or PN
parallax. For one target, GJ 876, theoretical dynamical modelers have
proposed an inclination closer to 50 degrees, while FGS3 measurements
indicated an inclination closer to 84 degrees. These new data, once
combined with our older FGS3 data, will permit an independent
remeasurement of the inclination of the outermost companion, and a re-
evaluation of widely used dynamical algorithms.

NIC1/NIC2/NIC3/S/C 11406

NICMOS DC Transfer Function Test

This early activity following the re-activation and re-cooling of
NICMOS following SM4 is designed to test the basic operability of the
NICMOS HgCdTe photodiode array focal plane detectors without exposure
to external stimulating irradiation. This test requires "special
commanding" and "non-standard" instrument state transition scheduling.
This test is to be executed following NCS cool-down and equilibration
of the NICMOS detectors at their anticipated nominal Cycle 17
operating temperatures.

Detector operability and dark functionality will be assessed from
executing a bias- voltage ramped series series non-stimulated (dark)
multiple non-destructive readout exposures; with the detector bias
voltages ramped in 0.1V commanded steps from 0 volts DC to 0.6 volts
DC. These data MUST be taken in parallel in all three cameras, and
make use of "non- standard" multi-accum sample-sequences, as we will
compare these results directly to multiple pre-launch runs of the
NICMOS System Test as well as the execution of SM2/NIC 7037 and
SM3B/8976.

STIS/CCD 11844

CCD Dark Monitor Part 1

The purpose of this proposal is to monitor the darks for the STIS CCD.

STIS/CCD 11846

CCD Bias Monitor-Part 1

The purpose of this proposal is to monitor the bias in the 1x1, 1x2,
2x1, and 2x2 bin settings at gain=1, and 1x1 at gain = 4, to build up
high-S/N superbiases and track the evolution of hot columns.

STIS/MA1/MA2 11857

STIS Cycle 17 MAMA Dark Monitor

This proposal monitors the behavior of the dark current in each of the
MAMA detectors.

The basic monitor takes two 1380s ACCUM darks each week with each
detector. However, starting Oct 5, pairs are only included for weeks
that the LRP has external MAMA observations planned. The weekly pairs
of exposures for each detector are linked so that they are taken at
opposite ends of the same SAA free interval. This pairing of exposures
will make it easier to separate long and short term temporal
variability from temperature dependent changes.

For both detectors, additional blocks of exposures are taken once
every six months. These are groups of five 1314s FUV-MAMA Time-Tag
darks or five 3x315s NUV ACCUM darks distributed over a single
SAA-free interval. This will give more information on the brightness
of the FUV MAMA dark current as a function of the amount of time that
the HV has been on, and for the NUV MAMA will give a better measure of
the short term temperature dependence.

WFC3/IR/S/C 11929

IR Dark Current Monitor

Analyses of ground test data showed that dark current signals are more
reliably removed from science data using darks taken with the same
exposure sequences as the science data, than with a single dark
current image scaled by desired exposure time. Therefore, dark current
images must be collected using all sample sequences that will be used
in science observations. These observations will be used to monitor
changes in the dark current of the WFC3-IR channel on a day-to-day
basis, and to build calibration dark current ramps for each of the
sample sequences to be used by GOs in Cycle 17. For each sample
sequence/array size combination, a median ramp will be created and
delivered to the calibration database system (CDBS).

WFC3/UVIS 11650

Mutual Orbits, Colors, Masses, and Bulk Densities of 3 Cold Classical
Trans-Neptunian Binaries

Many Trans-Neptunian Objects (TNOs) have been found to be binary or
multiple systems. As in other astrophysical settings, Trans-Neptunian
Binaries (TNBs) offer uniquely valuable information. Their mutual
orbits allow the direct determination of their system masses, perhaps
the most fundamental physical quantity of any astronomical object.
Their frequency of occurrence and dynamical characteristics provide
clues to formation conditions and evolution scenarios affecting both
the binaries and their single neighbors. Combining masses with sizes,
bulk densities can be measured. Densities constrain bulk composition
and internal structure, key clues to TNO origins and evolution over
time. Several TNB bulk densities have been determined, hinting at
interesting trends. But none of them belongs to the Cold Classical
sub- population, the one group of TNOs with demonstrably distinct
physical characteristics. Two top-priority Spitzer programs will soon
observe and measure the sizes of 3 Cold Classical TNBs. This proposal
seeks to determine the mutual orbits and thus masses of these systems,
enabling computation of their densities.

WFC3/UVIS 11905

WFC3 UVIS CCD Daily Monitor

The behavior of the WFC3 UVIS CCD will be monitored daily with a set
of full-frame, four-amp bias and dark frames. A smaller set of 2Kx4K
subarray biases are acquired at less frequent intervals throughout the
cycle to support subarray science observations. The internals from
this proposal, along with those from the anneal procedure (Proposal
11909), will be used to generate the necessary superbias and superdark
reference files for the calibration pipeline (CDBS).

WFC3/UVIS 11908

Cycle 17: UVIS Bowtie Monitor

Ground testing revealed an intermittent hysteresis type effect in the
UVIS detector (both CCDs) at the level of ~1%, lasting hours to days.
Initially found via an unexpected bowtie-shaped feature in flatfield
ratios, subsequent lab tests on similar e2v devices have since shown
that it is also present as simply an overall offset across the entire
CCD, i.e., a QE offset without any discernable pattern. These lab
tests have further revealed that overexposing the detector to count
levels several times full well fills the traps and effectively
neutralizes the bowtie. Each visit in this proposal acquires a set of
three 3x3 binned internal flatfields: the first unsaturated image will
be used to detect any bowtie, the second, highly exposed image will
neutralize the bowtie if it is present, and the final image will allow
for verification that the bowtie is gone.

WFC3/UVIS 11912

UVIS Internal Flats

This proposal will be used to assess the stability of the flat field
structure for the UVIS detector throughout the 15 months of Cycle 17.
The data will be used to generate on- orbit updates for the delta-flat
field reference files used in the WFC3 calibration pipeline, if
significant changes in the flat structure are seen.

WFC3/UVIS/IR 11909

UVIS Hot Pixel Anneal

The on-orbit radiation environment of WFC3 will continually generate
new hot pixels. This proposal performs the procedure required for
repairing those hot pixels in the UVIS CCDs. During an anneal, the
two-stage thermo-electric cooler (TEC) is turned off and the
four-stage TEC is used as a heater to bring the UVIS CCDs up to ~20
deg. C. As a result of the CCD warmup, a majority of the hot pixels
will be fixed; previous instruments such as WFPC2 and ACS have seen
repair rates of about 80%. Internal UVIS exposures are taken before
and after each anneal, to allow an assessment of the procedure's
effectiveness in WFC3, provide a check of bias, global dark current,
and hot pixel levels, as well as support hysteresis (bowtie)
monitoring and CDBS reference file generation. One IR dark is taken
after each anneal, to provide a check of the IR detector.

FLIGHT OPERATIONS SUMMARY:

Significant Spacecraft Anomalies: (The following are preliminary
reports of potential non-nominal performance that will be
investigated.)

HSTARS: (None)

COMPLETED OPS REQUEST: (None)

COMPLETED OPS NOTES: (None)

SCHEDULED SUCCESSFUL
FGS GSAcq 7 7
FGS REAcq 6 6
OBAD with Maneuver 6 6

SIGNIFICANT EVENTS: (None)