![]() |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Last night I had somewhat better seeing than the night before so my tests of
the new IMG1024S Dream Machine continued but with somewhat better results. I ended up concentrating on the "tadpoles" in IC410, continuing on an object that I had taken a few test exposures of the prior night. I used the very nice "suburban friendly" Custom Scientific 3nm FWHM Halpha filter to take seven exposures of a half hour each. I can say with zero hesitation that the 3nm Custom Scientific Ha filter is the best Halpha filter I have ever used. My comparison set so far consists of the set of 3nm Cs, 4.5nm CS, 6nm AD, 9nm pre-AD Schuler. I still haven't yet tested the new 7nm Baader but am excited to see a nice $300 solution for 50mm that, based on the work of others, appears to work every bit as well as the higher priced 6nm filters that seem to be so popular, but at less than half the price! The seeing still was not all that great due to upper air disturbances caused by the position of the jet stream, but was definitely better than Wed night. Hopefully I will have good seeing soon, because I would like to shoot the scope at full focal length, without the reducer (5760mm vs 3366mm), to continue my testing. The Dream Machine's big 24 x 24 micron back-illuminated pixels are like a photon vacuum cleaner compared to the "ccd with sunglasses" performance I see with the KAF3200ME sensor. Not a bad sensor at all, mind you, but it is in a different league with the 6.8 x 6.8 micron microlensed pixels. When the seeing is good, then it is a lot of fun to use on the stinger at 0.42 arc-sec/pixel. The DM used with the reducer gives me 1.42 arc-sec/pixel and without it is 0.86 ASP. I processed the image two ways: with and without deconvolution. In this case due to the decent s/n I get from the big pixels exposed through a 3nm filter at f/7.1 I can tolerate some deconvolution without mucking up the image. It is a pleasure to have so much signal after operating in starvation mode for the past month taking the data for Jones 1. http://www.narrowbandimaging.com/ic4...ch_ha_page.htm comments welcome. |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
ASTRO: First Light Tests of FLI Dream Machine on Stinger 450 classical cassegrain at f/7.1 | Richard Crisp | Astro Pictures | 6 | December 1st 06 05:12 AM |
"Most complex machine ever built"? | Richard | Space Shuttle | 24 | October 27th 06 02:21 AM |
"VideO Madness" "Pulp FictiOn!!!," ...., and "Kill Bill!!!..." | Colonel Jake TM | Misc | 0 | August 26th 06 09:24 PM |
"VideO Madness" "DO yOu want?!?!?!..." 'and' "GoD HATES FAGS!!!..." | Colonel Jake TM | Misc | 0 | August 13th 06 07:28 AM |