![]() |
|
#1
|
|||
|
|||
![]()
On Fri, 11 Jul 2003 20:56:05 GMT, "Michael Barlow"
wrote: Everything I read tells me everything I want to know about buying a pier and bolting it to the floor of my observatory. But I wont have a floor, just dirt, and I don't want to buy a pier. So, what should I do? My plans were to dig 4 foot down (frost line) and plant a 10 inch Sono-tube + 4 foot above ground. Fill it with cement topped off with 4 J bolts to bolt the mount to. 10 inches seems awfully big! I'm going to be setting a Meade 127mm F/5 refractor on this with a heavy mount (30ish lb.) and an OM-1 for astrophotography. What's the best size for a pier with that in mind, 6", 8", 10"? and what perameters should I be considering? There's no reason at all to buy a pier- none of the commercial models offer anything you can't easily provide yourself, and some have things like level adjustments that you absolutely want to avoid. Your decision not to put in a floor is also a good one, and will increase your performance both mechanically and thermally. My pier is 6" well casing (6.5" OD) filled with oiled sand. It is rock solid with a 12" LX200 and a lot of additional equipment on it. Cement by itself can support some interesting vibrations, so I think your instinct to use 10" sonotube is good. Be sure to put some rebar in there, and I'd suggest a fiber reinforced concrete. You could save some concrete by putting a 6" sonotube in the center of the 10", and pouring only in the outer area. Then fill the inside with sand, possible oiled, to help further damp vibrations. The foundation is even more important. I'm down only about 3 feet, above the frost line but sitting on solid rock. So I only have about an 18" round foundation at the bottom, maybe 6" high. If you can't get down to rock, consider a 3 to 4 foot square foundation at the bottom of your hole. With a permanent polar alignment, you don't want the angle of your pier drifting by even a few arcseconds. Are you building a platform floor around the pier? If not, consider it. This will be much more comfortable to work on than the ground. It only requires a few hours to put one in, but you need to plan on your pier being 12-18 inches higher if you do that. _________________________________________________ Chris L Peterson Cloudbait Observatory http://www.cloudbait.com |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
An experiment I did | Niko Holm | Policy | 24 | January 23rd 04 03:00 PM |
piers | gig50 | Amateur Astronomy | 2 | July 11th 03 08:14 PM |