Il giorno domenica 9 ottobre 2016 16:30:21 UTC+2, Jeff Findley ha scritto:
In article ,
says...

http://forum.nasaspaceflight.com/ind...?topic=40170.0

https://neolegesmotus.wordpress.com/...-the-take-off/


Last post in the thread from the forum link above (emphasis mine):

EmDrive Builder
Full Member
****

Posts: 1953
On My Own Domain
Liked: 2374
Likes Given: 1073
Non Newtonian Propulsion System (PNN) - Related to Space Flight
Applications
« Reply #21 on: 05/12/2016 06:41 PM »

********** Locking for lack of interest. **********

Any detail
May 2 2016 I "..." said in such forum
"My english is very bad
more it's better if I don't write on your forum because I couldn't say anything more than what I'm doing right now (SergioZ Translate for you a my "Note about PNN for NASA spaceflight forum " for this forum)"
Such discussion was closed May 12 2016


I'll also note that the thread was locked after several people pointed
out the possible errors induced by running a power cord to the
experiment from a fixed power supply. Such errors have happened in
other experiments (as indicated by the other posters in the thread).

So, not sure why this thread has been posted here. Looking for a more
receptive audience, or pointing out that the EmDrive still looks
"fishy" at first glance?

it is necessary to construct the pnn detection system so that it is independent of the thermal deformation; many details about ballist pendulum setup are necessary to give whenever possible.
At the end, for a cross-check for use in pnn measurement of the thrust also what is used to measure the thrust of the ion engine


E.Laureti