Was this the same problem as with the old tank? was it the same sensor?

It smells like an electronic circuit problem, rather than a sensor one,
especially if it can be duplicated. Some mileage might be gained by looking
at the history of this sensor and if anything has been altered over the last
few tanks.
If the hysteresis is caused by electronics, and those electronics are in the
sensor, then I suppose either might be some faulty units, but if the
electronics are in the orbiter, maybe the answer is to switch around the
outputs from the sensors to different processing channels and run a tanking
test.

Brian

--
Brian Gaff....Note, this account does not accept Bcc: email.
graphics are great, but the blind can't hear them
Email:
__________________________________________________ __________________________________________________ __________