Andy Dix wrote:
Can any shed some light on the "Support Ring" output obtained from Plop?
For example I get...
Radius = 0.399586
Radius = 0.834338
I just want to know how I might divide my circle up for positioning of the
various triangle supports and bars.

Right I think I've found the answer to my own question.
If I multiply the radius of my mirror by the radius figure given by Plop for
each "ring" I seem to get the correct support rings to line everything up
with.

At least I know what I'm going on about even if nobody else does. ;o)

--
Regards
Andy